Verity NeuroTrac Rehab, Dual Channel TENS and NMES Unit

The Verity NeuroTrac Rehab Device offers many different functionalities, ranging from 10 pre-set programs and 10 pre-set neuromuscular stimulating programs. It also is a remote switch control devices that facilitates a range of rehabilitation protocols, including Foot Drop, which offers comfort and care at your finger tips.


  • Digital Dual channel TENS and NMES device with remote switch controlled programmes
  • 2 customisable TENS and 1 customisable remote STIM programme
  • 10 Pre-set TENS programmes & Neuromuscular Stimulation programmes
  • The wired remote switch control of mA by the patient (to speed up the neuro-muscular re-education) facilitates a range of rehabilitation protocols, including Foot Drop
  • Clear bright backlight LCD display
  • Lock mode function for measuring and recording home compliance (mA and total time used).
  • Keypad with bigger buttons for ease of use
  • Compact, light and reliable




Physical Dimensions

119.2 x 69 x 28.7mm


0.07kg without battery, 0.1kg with battery

Dual Channel

Individually isolated circuits.


0-90 mA into 500 Ohm load ; indication only. Actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 70 mA, at 1500 Ohms load the maximum will be limited to 65 mA.


Constant Current, maximum output voltage 180 Volts +10 / -30 Volts.


Asymmetrical, rectangular bi-phasic with zero DC current.

Selectable Pulse Width

50 ìS – 450 μS [2% accuracy].

Pulse Rate Selection

In the continuous mode 2 – 200 Hz [2% accuracy].


Continuous, Burst or Modulated.

Burst mode: Bursts of 9 pulses [200 μS] at 150 Hz or 185 Hz, over 2 seconds.

Modulation mode: 6-second cycle of concurrent width modulation and pulse repetition rate modulation. TENS 7: Width starting at 50 ìS and increasing exponentially to 250μS in three seconds and then returning back to 50 ìS in the next three seconds. Rate starting 20 Hz, increasing exponentially to 85 Hz and then returning to 100 Hz. TENS 8: Width fixed at 200 μS. Rate starting 32 Hz, increasing exponentially to 100 Hz over 3 seconds and then returning to 32 Hz in the next 3 seconds.

Time duration of the custom programmes selectable

1 minute to 12 hours.

Low Battery Indicator

If the battery goes below 6.9 volts +/- 0.2 volts the battery symbol will flash on/off once every second.

If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn on.

Open Electrode Detect

If an open circuit is detected at the output of channel A or B the output current will be reset at zero.

Environmental Conditions

For Use: +5 to +40 degrees Centigrade. 15-93% Humidity.

For Storage & Transport: -25 to +70 degrees Centigrade. 15-93% Humidity.

Accessories supplied with device

Dual lead wire x 2
Self-adhesive electrodes (50 x 50mm)
9V PP3 battery
Soft bag
Operating manual
Goft box

Contact Us

  • This field is for validation purposes and should be left unchanged.